Seam Sealing Tape T-2000X – Hot Melt 3-Layer Waterproof – 5 Metres - Iron On (Navy Blue, 22mm Width)

The tape was much easier to put on than I thought it was going to be. The tip I read about putting a strip of wood under your garment to raise it and get a solid base to iron in worked a treat. I put the iron on no-steam medium hot 2.5 with 3 as max. Place the strip on seam. Hold in place and use the front of the iron to seal it in place. Then go back over the tape to stick it on properly, making sure you put the iron right to edges until you see the glue coming out to make sure it's properly stuck down. I used greaseproof paper to protect my waterproofs but not sure it's needed. The tapes seems solid enough and sealed well but time will tell, especially after a wash.

Bought this to repair an older jacket. It has been easy to apply and appears well stuck, sealing the seams as expected. The only snag is I need more. So ordered another roll as this is so much less expensive than a new jacket.

Good quality

I bought this to repair the damaged (10 years old) seam sealing tape at my Dynesse Gore Tex motorbike jacket and trousers . The quality of the product is very good. I made the repair twice. The 1st time I applied it using the iron at a medium temperature by pressing it for about 5 sec but it didn't stick well. The 2nd time I applied it using the iron at a medium to high temperature (at the point where the iron starts to steam) by pressing it for 10 seconds until a little amount of the glue showed at the edges of the tape. By doing this, tape stuck very well and no water passed through during a rainy day I tested it. Unfortunately, because of the material feeling of the Gore Tex fabric (it has a silicon feel at touching) and the position of the fixed area ( inside of the arm where it folds) the tape after 10 days of everyday use, started to unstick lightly at specific areas, without loosing its waterproof abilities. Maybe it unstuck only at the edges. In my opinion, if the repair was at an another area of the jacket that doesn't fold all the time, it would probably had been stuck better, because at the Gore tex trousers it stuck very strong and until now it has no problem. Here and some photos of the repair. 1st photo is from the jacket arm, 2nd is from the trousers and the 3rd is from jacket after several days. So I will surely try again until I succeed the better result. I 'll give to this product a rate of 5 stars ( I was thinking to give 4), only because I think that maybe I didn't make a proper application.

I used this on a 30 (yes 30!) year old three layer Goretex Sprayway mountain shell jacket where the original seam taping across the collar had lifted and edges of original taping had lifted in places. Very successful. It’s a bit of a slow fiddly job and patience needed but results very good indeed. Tip - get a foot long piece of 2”x1” wood to put on the ironing board under garment and the length of seam being repaired. You can adjust position of garment and wood strip as you go.This lifts the seam above the rest of the garment giving you a clear run with the iron, a hard base to iron on and helps avoid touching the rest of the garment with the iron. I set the iron a little over the two dot medium heat setting which wororked for me. You can cut the new seam tape to make a narrower width if required. Cut its length to a bit more than the length of seam being repaired. You can trim later if it’s a bit too long. You’ll find that you miss little bits with the iron so inspect the repaired areas carefully especially edges and go over any unstuck edges carefully with the edge of the iron. In places Where the original seam tape was only lifting slightly at edges I cut the new taoe into narrower strips, about 1cm wide, and used these just to seal over the edges of the original tape. The jacket is now good for another 30 years?! So the £15 was well spent to get what is now equivalent to a £300 jacket fit for purpose again. An amateur repair but this tape enables results probably not far off a more costly professional repair.

An excellent product, great quality at a very good price that made the repair I needed very easy, I would highly recommend this product.

I had to replace all the taped seams in a Goretex bivy bag at short notice. Ordered this product not knowing if it was going to work but fortunately it was easy to use and I ended up buying another roll to finish the job. Very easy to use and applied with a normal household iron. Use it on a hot setting but don’t use steam and the beauty of this tape is you don’t need to use a cloth over the top so you can see exactly where it’s going. The tip of the iron is precise enough to apply heat to the tape and you only need to apply heat long enough to activate the adhesive. If it’s not on long enough it’s easy to see where you need to re do it and if there are little bits that need redoing you just run the iron over it again till it’s done. So far the adhesive looks to have worked a treat and no signs of peeling off. Not had chance to test waterproofing in a real setting or in very cold temperatures but have no reason so far to doubt it’s effectiveness.